Hey guys/gals, this is going to be a simple thread on filling slin pins with oil. It doesn't matter if the oil is thick, thin, heated or not heated.
I can only do one pic per post so there will be 3 posts to start the thread.
After you put the pin in the vial and push the air in with the plunger, pull the plunger almost all the way out until it locks. If you pull it out too far, you will lose the seal so make sure you stop or you will have to replunge.
I can only do one pic per post so there will be 3 posts to start the thread.
After you put the pin in the vial and push the air in with the plunger, pull the plunger almost all the way out until it locks. If you pull it out too far, you will lose the seal so make sure you stop or you will have to replunge.
Comment